Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1404

www.dell.com | support.dell.com Example Figure 56-2. show redundancy Command Output FTOS#show redundancy -- SSeries Redundancy Configuration -- Auto reboot : Enabled -- Stack-unit Status -- Mgmt ID: 0 Stack-unit ID: 0 Stack-unit Redundancy Role: Primary Stack-unit State: Active Stack-unit SW Version: 7.7.1.0 Link to Peer: Up -- PEER Stack-unit Status -- Stack-unit State: Standby Peer stack-unit ID: 1 Stack-unit SW Version: 7.7.1.0 -- Stack-unit Redundancy Configuration -- Primary Stack-unit: mgmt-id 0 Auto Data Sync: Full Failover Type: Hot Failover Auto reboot Stack-unit: Enabled Auto failover limit: 3 times in 60 minutes -- Stack-unit Failover Record -- Failover Count: 0 Last failover timestamp: None Last failover Reason: None Last failover type: None -- Last Data Block Sync Record: -- Line Card Config: succeeded Mar 07 1996 00:27:39 Start-up Config: succeeded Mar 07 1996 00:27:39 Runtime Event Log: succeeded Mar 07 1996 00:27:39 Running Config: succeeded Mar 07 1996 00:27:39 ACL Mgr: succeeded Mar 07 1996 00:27:39 Related Commands redundancy disable-auto-reboot Prevent the system from auto-rebooting if it fails. show system stack-ports s Display information about the stacking ports on all switches in the S-Series stack. Syntax show system stack-ports [status | topology] Parameters status topology (OPTIONAL) Enter the keyword status to display the command output without the Connection field. (OPTIONAL) Enter the keyword topology to limit the table to just the Interface and Connection fields. Defaults No default behavior 1404 | S-Series Stacking Commands