Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 431

cam-acl (Configuration) c s Allocate CAM for IPv4 and IPv6 ACLs Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number, l2pt number ipmacacl number ecfmacl number [vman-qos | vman-dual-qos number} Parameters default l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number, l2pt number ipmacacl number ecfmacl number [vman-qos | vman-dual-qos number Use the default CAM profile settings, and set the CAM as follows. • L3 ACL (ipv4acl): 6 • L2 ACL(l2acl): 5 • IPv6 L3 ACL (ipv6acl): 0 • L3 QoS (ipv4qos): 1 • L2 QoS (l2qos): 1 Allocate space to each CAM region. Enter the CAM profile name followed by the amount to be allotted. The total space allocated must equal 13. The ipv6acl range must be a factor of 2. Command Modes CONFIGURATION Command History Version 8.3.1.0 Version 8.2.1.0 Version 7.8.1.0 Added ecfmacl, vman-qos, and vman-dual-qos keywords. Introduced on the S-Series Introduced on the C-Series Usage You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload Information the system for the new settings to take effect. The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be reallocated. When configuring space for IPv6 ACLs, the total number of Blocks must equal 13. Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). Content Addressable Memory (CAM) | 431