Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 408

www.dell.com | support.dell.com Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage FTOS resolves the network address configured by the network command with the routes in the main Information routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. Related Commands redistribute Redistribute routes into BGP. Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series redistribute c et s Redistribute routes into BGP. Syntax redistribute [connected | static] [route-map map-name] To disable redistribution, use the no redistribution [connected | static] [route-map map-name] command. Parameters connected static route-map map-name Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage If you do not configure default-metric command, in addition to the redistribute command, or there is no Information route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0.0.0.0/0) configure the neighbor default-originate command. Related Commands neighbor default-originate Inject the default route. 408 | Border Gateway Protocol IPv4 (BGPv4)