Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 865
port-channel-protocol lacp, show lacp, Table 29-1., LACP Modes, sys-id | counters, active, passive
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 865 highlights
Table 29-1. LACP Modes Mode active passive off Function An interface is in an active negotiating state in this mode. LACP runs on any link configured in the active state and also automatically initiates negotiation with other ports by initiating LACP packets. An interface is not in an active negotiating state in this mode. LACP runs on any link configured in the passive state. Ports in a passive state respond to negotiation requests from other ports that are in active states. Ports in a passive state respond to LACP packets. An interface can not be part of a dynamic port channel in the off mode. LACP will not run on a port configured in the off mode. port-channel-protocol lacp c e s Enable LACP on any LAN port. Syntax port-channel-protocol lacp To disable LACP on a LAN port, use the no port-channel-protocol lacp command. Command Modes INTERFACE Command History Version 6.2.1.1 Introduced Related Commands show lacp show interfaces port-channel Display the LACP information. Display information on configured Port Channel groups. show lacp c e s Display the LACP matrix. Syntax show lacp port-channel-number [sys-id | counters] Parameters port-channel-number sys-id counters Enter a port-channel number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. (OPTIONAL) Enter the keyword sys-id and the value that identifies a system. (OPTIONAL) Enter the keyword counters to display the LACP counters. Command Modes EXEC EXEC Privilege Command History Version 7.6.1.0 Support added for S-Series Link Aggregation Control Protocol (LACP) | 865