Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 759
distance bgp, maximum-paths
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 759 highlights
Command History Related Commands Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 router bgp Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Enter ROUTER mode on the switch. distance bgp c e Configure three administrative distances for routes. Syntax distance bgp external-distance internal-distance local-distance To return to default values, enter no distance bgp. Parameters external-distance internal-distance local-distance Enter a number to assign to routes learned from a neighbor external to the AS. Range: 1 to 255. Default: 20 Enter a number to assign to routes learned from a router within the AS. Range: 1 to 255. Default: 200 Enter a number to assign to routes learned from networks listed in the network command. Range: 1 to 255. Default: 200 Defaults external-distance = 20; internal-distance = 200; local-distance = 200. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Caution: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. Usage The higher the administrative distance assigned to a route means that your confidence in that route is Information low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. maximum-paths c e Configure the maximum number of parallel routes (multipath support) BGP supports. IPv6 Border Gateway Protocol (IPv6 BGP) | 759