Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1027
ip ospf transmit-delay, log-adjacency-changes, max-metric router-lsa
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1027 highlights
ip ospf transmit-delay c e s Set the estimated time elapsed to send a link state update packet on the interface. Syntax ip ospf transmit-delay seconds To return to the default value, enter no ip ospf transmit-delay. Parameters seconds Enter the number of seconds as the transmission time. This value should be greater than the transmission and propagation delays for the interface. Range: 1 to 3600. Default: 1 second. Defaults 1 second Command Modes INTERFACE Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series log-adjacency-changes c e s Generate a Syslog message for OSPF adjacency state changes. When enabled, changes are logged for both IPv4 and IPv6 adjacencies. Syntax log-adjacency-changes Defaults Disabled. Command Mode ROUTER OSPF Command History Version 8.4.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced for IPv6. Introduced support for Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series max-metric router-lsa c e Configure the maximum cost of 65535 on a new router so that it functions as a stub router in the network and OSPF traffic destined to other networks is not forwarded on a path through the router. Syntax max-metric router-lsa [on-startup {announce-time | wait-for-bgp [wait-time]}] To remove the maximum metric assignment from an OSPF router and send LSAs with the currently configured cost, enter no max-metric router-lsa [on-startup {announce-time | wait-for-bgp [wait-time]}]. Open Shortest Path First (OSPFv2 and OSPFv3) | 1027