Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1356
show snmp
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1356 highlights
www.dell.com | support.dell.com Important Points to Remember • Typically, 5-second timeout and 3-second retry values on an SNMP server are sufficient for both LAN and WAN applications. If you experience a timeout with these values, the recommended best practice on Dell Force10 switches (to accommodate their high port density) is to increase the timeout and retry values on your SNMP server to the following: - SNMP Timeout-greater than 3 seconds - SNMP Retry count-greater than 2 seconds • If you want to query an E-Series switch using SNMP v1/v2/v3 with an IPv6 address, configure the IPv6 address on a non-management port on the switch. • If you want to send SNMP v1/v2/v3 traps from an E-Series using an IPv6 address, use a non-management port. • SNMP v3 informs are not currently supported with IPv6 addresses. • If you are using ACLs in SNMP v3 configuration, group ACL overrides user ACL if the user is part of that group. • SNMP operations are not supported on a VLAN. show snmp c e s Display the status of SNMP network elements. Syntax show snmp Command Modes EXEC EXEC Privilege Command History Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command Example Figure 54-1. show snmp Command Example FTOS#show snmp 32685 SNMP packets input 0 Bad SNMP version errors 0 Unknown community name 0 Illegal operation for community name supplied 0 Encoding errors 96988 Number of requested variables 0 Number of altered variables 31681 Get-request PDUs 968 Get-next PDUs 0 Set-request PDUs 61727 SNMP packets output 0 Too big errors (Maximum packet size 1500) 9 No such name errors 0 Bad values errors 0 General errors 32649 Response PDUs 29078 Trap PDUs FTOS# Related Commands snmp-server community Enable SNMP and set community string. 1356 | SNMP and Syslog