Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 857

detail interface (OPTIONAL) Displays detailed information about neighbors. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Command Modes EXEC EXEC Privilege Example Figure 28-8. Command Example: show isis neighbors FTOS#show isis neighbors System Id Interface State Type Priority Uptime Circuit Id TEST Gi 7/1 Up L1L2(M) 127 09:28:01 TEST.02 ! FTOS#show isis neighbors detail System Id Interface State Type Priority Uptime Circuit Id TEST Gi 7/1 Up L1L2(M) 127 09:28:04 TEST.02 Area Address(es): 49.0000.0001 IP Address(es): 25.1.1.3* MAC Address: 0000.0000.0000 Hold Time: 28 Link Local Address: fe80::201:e8ff:fe00:492c Topology: IPv4 IPv6 , Common (IPv4 IPv6 ) Identified Multi-Topology ISIS enabled Adjacency being used for MTs: IPv4 IPv6 FTOS# Table 28-2. show isis neighbors Command Example Fields Field System Id Interface State Type Priority Uptime Circuit Id Description The value that identifies a system in an area. The interface, slot, and port in which the router was discovered. The value providing status about the adjacency state. The valid values are Up and Init. This value displays the adjacency type (Layer 2, Layer 2 or both). IS-IS priority advertised by the neighbor. The neighbor with highest priority becomes the designated router for the interface. Displays the interfaces uptime. The neighbor's interpretation of the designated router for the interface. Usage Information Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are not, you can verify the specified area addresses of the routers by using the show isis neighbors command. Intermediate System to Intermediate System (IS-IS) | 857