Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1224
Queue-Level Debugging, clear queue statistics egress
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1224 highlights
www.dell.com | support.dell.com Command History pre-Version 6.1.1.1 Introduced on E-Series Usage Use the default pre-defined profiles or configure your own profile. You can not delete the pre-defined Information profiles or their default values. This command enables the WRED configuration mode-(conf-wred). Related Commands threshold Specify the minimum and maximum threshold values of the WRED profile Queue-Level Debugging Queue-Level Debugging is an E-Series-only feature, as indicated by the e character that appears below each command heading. The following queuing statistics are available on both the EtherScale and TeraScale versions of E-Series systems. • clear queue statistics egress • clear queue statistics ingress • show queue statistics egress • show queue statistics ingress clear queue statistics egress e Clear egress queue statistics. Syntax clear queue statistics egress [unicast | multicast] [Interface] Parameters unicast | multicast Interface (OPTIONAL) Enter the keyword multicast to clear only Multicast queue statistics. Enter the keyword unicast to clear only Unicast queue statistics. Default: Both Unicast and Multicast queue statistics are cleared. (OPTIONAL) Enter one of the following interfaces to display the interface specific queue statistics. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • Fast Ethernet is not supported Defaults No default behavior or values Command Modes EXEC EXEC Privilege Command History Version 6.2.1.1 Introduced 1224 | Quality of Service (QoS)