Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 656

www.dell.com | support.dell.com • IP source address • IP destination address • IP Protocol type • TCP/UDP source port • TCP/UDP destination port Note: For IPV6, only the first 32 bits (LSB) of IP Source Address and IP Destination Address are used for hash generation. The table below lists the load balance command options and how the command combinations effect the distribution of traffic. Table 24-3. Configurations of the load-balance Command Configuration Default (IP 5-tuple) ip-selection 3-tuple mac ip-selection 3-tuple and mac ip-selection packet-based ip-selection packet-based and mac Switched IP Traffic IP 5-tuple IP 3-tuple MAC based MAC based Packet based: IPV4 No distribution: IPV6 MAC based Routed IP Traffic (IPV4 Only) IP 5-tuple IP 3-tuple IP 5-tuple IP 3-tuple Packet based: IPV4 Packet based: IPV4 Switched Non-IP Traffic MAC based MAC based MAC based MAC based MAC based MAC based Related Commands ip address Change the algorithm used to distribute traffic on an E-Series chassis. management route c e Configure a static route that points to the Management interface or a forwarding router. Syntax management route {ipv4-address | ipv6-address}/mask {forwarding-router-address | managementethernet} Parameters {ipv4-address | ipv6-address}/ mask forwarding-router-address managementethernet Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X), followed by the prefix-length for the IP address of the management interface. Enter an IPv4 or IPv6 address of a forwarding router. Enter the keyword managementethernet for the Management interface on the Primary RPM. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.4.1.0 Version 8.1.1.0 Added support for IPv6 management routes. Introduced on E-Series ExaScale 656 | IPv4 Routing