Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1237
no default-information originate, debug ip rip
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1237 highlights
Syntax debug ip rip [interface | database | events [interface] | packet [interface] | trigger] To turn off debugging output, use the no debug ip rip command. Parameters interface database events packet trigger (OPTIONAL) Enter the interface type and ID as one of the following: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Note: This option is available only on E-Series when entered as a standalone option. It is available on both C-Series and E-Series as a sub-option. (OPTIONAL) Enter the keyword database to display messages when there is a change to the RIP database. (OPTIONAL) Enter the keyword events to debug only RIP protocol changes. (OPTIONAL) Enter the keyword events to debug only RIP protocol packets. Note: This option is available only on C-Series. (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions. Command Modes EXEC Privilege Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series default-information originate c e s Generate a default route for the RIP traffic. Syntax default-information originate [always] [metric metric-value] [route-map map-name] To return to the default values, enter no default-information originate. Parameters always metric metric-value route-map map-name (OPTIONAL) Enter the keyword always to enable the switch software to always advertise the default route. (OPTIONAL) Enter the keyword metric followed by a number as the metric value. Range: 1 to 16 Default: 1 (OPTIONAL) Enter the keyword route-map followed by the name of a configured route-map. Router Information Protocol (RIP) | 1237