Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 847

Defaults Not configured. Command Modes ROUTER ISIS passive-interface e Suppress routing updates on an interface. This command stops the router from sending updates on that interface. Syntax passive-interface interface To delete a passive interface configuration, enter the no passive-interface interface command. Parameters interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interface, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes ROUTER ISIS Usage Although the passive interface will neither send nor receive routing updates, the network on that Information interface will still be included in IS-IS updates sent via other interfaces redistribute e Redistribute routes from one routing domain to another routing domain. Syntax redistribute {static | connected | rip} [level-1 | level-1-2 | level-2] [metric metric-value] [metric-type {external | internal}] [route-map map-name] To end redistribution or disable any of the specified keywords, enter the no redistribute {static | connected | rip} [metric metric-value] [metric-type {external | internal}] [level-1 | level-1-2 | level-2] [route-map map-name] command. Parameters connected rip static Enter the keyword connected redistribute active routes into IS-IS. Enter the keyword rip to redistribute RIP routes into IS-IS. Enter the keyword static to redistribute user-configured routes into IS-IS. Intermediate System to Intermediate System (IS-IS) | 847