Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1157
private-vlan mode
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1157 highlights
Command History Related Commands Version 7.8.1.0 Introduced on C-Series and S-Series private-vlan mode private-vlan mapping secondary-vlan show arp show interfaces private-vlan show vlan private-vlan switchport mode private-vlan Set the mode of the selected VLAN to community, isolated, or primary. Map secondary VLANs to the selected primary VLAN. Display the ARP table. Display type and status of PVLAN interfaces. Display PVLANs and/or interfaces that are part of a PVLAN. Set the PVLAN mode of the selected port. private-vlan mode c s Set the PVLAN mode of the selected VLAN to community, isolated, or primary. Syntax [no] private-vlan mode {community | isolated | primary} To remove the PVLAN configuration, use the no private-vlan mode {community | isolated | primary} command syntax. Parameters community isolated primary Enter community to set the VLAN as a community VLAN, as described above. Enter isolated to configure the VLAN as an isolated VLAN, as described above. Enter primary to configure the VLAN as a primary VLAN, as described above. Defaults none Command Modes INTERFACE VLAN Command History Version 7.8.1.0 Introduced on C-Series and S-Series Usage Information The VLAN: • Can be in only one mode, either community, isolated, or primary. • Mode can be set to community or isolated even before associating it to a primary VLAN. This secondary VLAN will continue to work normally as a normal VLAN even though it is not associated to a primary VLAN. (A syslog message indicates this.) • Must not have a port in it when the VLAN mode is being set. Only ports (and port channels) configured as promiscuous, host, or PVLAN trunk ports (as described above) can be added to the PVLAN. No other regular ports can be added to the PVLAN. After using this command to configure a VLAN as a primary VLAN, use the private-vlan mapping secondary-vlan command to map secondary VLANs to this VLAN. Related Commands private-vlan mapping secondary-vlan show interfaces private-vlan show vlan private-vlan Set the mode of the selected VLAN to primary and then associate secondary VLANs to it. Display type and status of PVLAN interfaces. Display PVLANs and/or interfaces that are part of a PVLAN. Private VLAN (PVLAN) | 1157