Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 772

www.dell.com | support.dell.com Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage Information The first time you enter this command it configures the neighbor as a route reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a route reflector. When all clients of a route reflector are disabled, the neighbor is no longer a route reflector. neighbor send-community c e Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that attribute belong to the same community grouping. Syntax neighbor {ipv6-address | peer-group-name} send-community To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-address | peer-group-name} send-community command. Parameters ipv6-address peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to send a COMMUNITY attribute to all routers within the peer group. Defaults Not configured and COMMUNITY attributes are not sent to neighbors. Command Modes ROUTER BGP Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale neighbor shutdown c e Disable a BGP neighbor or peer group. Syntax neighbor {ipv6-address | peer-group-name} shutdown To enable a disabled neighbor or peer group, use the no neighbor {ipv6-address | peer-group-name} shutdown command. Parameters ipv6-address peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to disable or enable all routers within the peer group. 772 | IPv6 Border Gateway Protocol (IPv6 BGP)