Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 623

Table 23-12. show interfaces port-channel Command Example Fields (continued) Field 0 64-byte... Received 0... Output 0... Rate information... Time since... Description Displays the size of packets and the number of those packets entering that interface. This information is displayed over two lines. Displays the type and number of errors or other specific packets received. This information is displayed over three lines. Displays the type and number of packets sent out the interface. This information is displayed over three lines. Displays the traffic rate information into and out of the interface. Traffic rate is displayed in bits and packets per second. Displays the time since the last change in the configuration of this interface. Figure 23-46. show interfaces port-channel brief Command Example FTOS#sh int por 1 br LAG Mode Status 1 L2 up FTOS# Uptime 00:00:08 Ports Gi 3/0 Gi 3/1 Gi 3/2 (Up) * (Down) (Up) Table 23-13. show interfaces port-channel brief Command Example Fields Field LAG Mode Status Uptime Ports (untitled) Description Lists the port channel number. Lists the mode: • L3 - for Layer 3 • L2 - for Layer 2 Displays the status of the port channel. • down - if the port channel is disabled (shutdown) • up - if the port channel is enabled (no shutdown) Displays the age of the port channel in hours:minutes:seconds. Lists the interfaces assigned to this port channel. Displays the status of the physical interfaces (up or down). In Layer 2 port channels, an * (asterisk) indicates which interface is the primary port of the port channel. The primary port sends out interface PDU. In Layer 3 port channels, the primary port is not indicated. Related Commands show lacp Display the LACP matrix. Interfaces | 623