Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 801

Parameters external-distance internal-distance local-distance Enter a number to assign to routes learned from a neighbor external to the AS. Range: 1 to 255. Default: 20 Enter a number to assign to routes learned from a router within the AS. Range: 1 to 255. Default: 200 Enter a number to assign to routes learned from networks listed in the network command. Range: 1 to 255. Default: 200 Defaults external-distance = 20; internal-distance = 200; local-distance = 200. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series TeraScale Caution: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. Usage Information The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. neighbor activate c e This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI. Syntax neighbor [ipv6-address | peer-group-name] activate To disable, use the no neighbor [ipv6-address | peer-group-name] activate command. Parameters ipv6-address peer-group-name activate (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group Enter the keyword activate to enable the neighbor/peer group in the new AFI/SAFI. Defaults Disabled Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series TeraScale IPv6 Border Gateway Protocol (IPv6 BGP) | 801