Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 727
brief] [con d] [gigabitethernet, show ipv6 interface
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 727 highlights
show ipv6 interface c e s Display the status of interfaces configured for IPv6. Syntax show ipv6 interface interface [brief] [configured] [gigabitethernet slot | slot/port] [linecard slot-number] [loopback interface-number] [managementethernet slot/port] [port-channel number] [tengigabitethernet slot | slot/port] [vlan vlan-id] Parameters interface brief configured gigabitethernet linecard slot-number managementethernet slot/port loopback port-channel tengigabitethernet vlan (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword Loopback followed by a number from 0 to 16383. • For the Null interface, enter the keyword null followed by zero (0). • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) View a summary of IPv6 interfaces. (OPTIONAL) View information on all IPv6 configured interfaces (OPTIONAL) View information for an IPv6 gigabitethernet interface. (OPTIONAL) View information for a specific IPv6 linecard or S-Series stack-unit Range: 0 to 13 on a E1200, 0 to 6 on a E600, and 0 to 5 on a E300. Range: 0-7 for C-Series Range 0-7 for S-Series (OPTIONAL) View information on an IPv6 Management port. Enter the slot number (0-1) and port number zero (0). (OPTIONAL) View information for IPv6 loopback interfaces. (OPTIONAL) View information for IPv6 port channels. (OPTIONAL) View information for an IPv6 tengigabitethernet interface. (OPTIONAL) View information for IPv6 VLANs. Defaults No default values or behavior Command Modes EXEC EXEC Privilege Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on S-Series Introduced on E-Series ExaScale. Support for the managementethernet slot/port parameter was added. Introduced on C-Series Introduced on E-Series TeraScale Usage The Management port is enabled by default (no shutdown). If necessary, use the ipv6 address Information command to assign an IPv6 address to the Management port. IPv6 Basics | 727