Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1123

ipv6 pim join-filter e Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group. Syntax ipv6 pim join-filter access-list Parameters access-list in out Enter the name of an extended access list. Enter this keyword to apply the access list to inbound traffic. Enter this keyword to apply the access list to outbound traffic. Defaults None Command Modes INTERFACE Command History Example Version 8.3.1.0 Introduced FTOS(conf)#ipv6 access-list JOIN-FIL_ACL FTOS(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::225:1:2:0/112 FTOS(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112 FTOS(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any FTOS(conf-ipv6-acl)#exit FTOS(conf)#interface gigabitethernet 0/84 FTOS(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in FTOS(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out ipv6 pim query-interval e Change the frequency of IPv6 PIM Router-Query messages. Syntax ipv6 pim query-interval seconds To return to the default value, enter no ipv6 pim query-interval seconds command. Parameters seconds Enter a number as the number of seconds between router query messages. Default: 30 seconds Range: 0 to 65535 Defaults 30 seconds Command Modes INTERFACE Command History Version 7.4.1.0 Introduced ipv6 pim neighbor-filter e Prevent the system from forming a PIM adjacency with a neighboring system. Syntax ipv6 pim neighbor-filter {access-list} Parameters access-list Enter the name of a standard access list. Maximum 16 characters. PIM-Sparse Mode (PIM-SM) | 1123