Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 748

www.dell.com | support.dell.com Related Commands Command History clear ip bgp ipv6 unicast soft Activate inbound policies for IPv6 routes without resetting the BGP TCP in session. Version 8.4.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.2.1.0 Added support for IPv4 multicast and IPv6 unicast address families Introduced support on S4810 Introduced support on C-Series Introduced on E-Series TeraScale capture bgp-pdu neighbor (ipv6) c e Enable capture of an IPv6 BGP neighbor packet. Syntax capture bgp-pdu neighbor ipv6-address direction {both | rx | tx} To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv6-address command. Parameters ipv6-address direction {both | rx | tx} Enter the IPv6 address of the target BGP neighbor. Enter the keyword direction and a direction- either rx for inbound, tx for outbound, or both. Defaults Not configured. Command Modes EXEC EXEC Privilege Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Related Commands capture bgp-pdu max-buffer-size show capture bgp-pdu neighbor capture bgp-pdu neighbor Enable route reflection between route reflector and clients. Configure a route reflector and clients. Enable capture of an IPv4 BGP neighbor packet. capture bgp-pdu max-buffer-size c e Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses. Syntax capture bgp-pdu max-buffer-size 100-102400000 Parameters 100-102400000 Enter a size for the capture buffer. Defaults 40960000 bytes 748 | IPv6 Border Gateway Protocol (IPv6 BGP)