Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1023

Parameters cost Enter a number as the cost. Range: 1 to 65535. Defaults The default cost is based on the reference bandwidth. Command Modes INTERFACE Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information If this command is not configured, cost is based on the auto-cost command. When you configure OSPF over multiple vendors, use the ip ospf cost command to ensure that all routers use the same cost. Otherwise, OSPF routes improperly. Related Commands auto-cost Control how the OSPF interface cost is calculated. ip ospf dead-interval c e s Set the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax ip ospf dead-interval seconds To return to the default values, enter no ip ospf dead-interval. Parameters seconds Enter the number of seconds for the interval. Range: 1 to 65535. Default: 40 seconds. Defaults 40 seconds Command Modes INTERFACE Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage By default, the dead interval is four times the default hello-interval. Information Related Commands ip ospf hello-interval Set the time interval between hello packets. Open Shortest Path First (OSPFv2 and OSPFv3) | 1023