Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1111

Table 41-1. show ip pim interface Command Example Fields Field Address Interface Ver/Mode Nbr Count Query Intvl DR Prio DR Description Lists the IP addresses of the interfaces participating in PIM. List the interface type, with either slot/port information or ID (VLAN or Port Channel), of the interfaces participating in PIM. Displays the PIM version number and mode for each interface participating in PIM. • v2 = PIM version 2 • S = PIM Sparse mode Displays the number of PIM neighbors discovered over this interface. Displays the query interval for Router Query messages on that interface (configured with ip pim query-interval command). Displays the Designated Router priority value configured on the interface (ip pim dr-priority command). Displays the IP address of the Designated Router for that interface. show ip pim neighbor c e s View PIM neighbors. Syntax show ip pim neighbor Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.8.1.0 Introduced on E-Series ExaScale Introduced on S-Series Example Figure 41-4. show ip pim neighbor Command Example FTOS#show ip pim neighbor Neighbor Interface Address 127.87.3.4 Gi 7/16 FTOS# Uptime/Expires Ver DR Prio/Mode 09:44:58/00:01:24 v2 1 / S Table 41-2. show ip pim neighbor Command Example Fields Field Neighbor address Interface Uptime/expires Description Displays the IP address of the PIM neighbor. List the interface type, with either slot/port information or ID (VLAN or Port Channel), on which the PIM neighbor was found. Displays the amount of time the neighbor has been up followed by the amount of time until the neighbor is removed from the multicast routing table (that is, until the neighbor hold time expires). PIM-Sparse Mode (PIM-SM) | 1111