Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1412
storm-control broadcast Configuration
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1412 highlights
www.dell.com | support.dell.com Parameters interface (OPTIONAL) Enter one of the following interfaces to display the interface specific storm control configuration. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • Fast Ethernet is not supported. Defaults No default behavior or values Command Modes EXEC EXEC Privilege Command History Version 7.6.1.0 Version 7.5.10 Version 6.5.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series Example E-Series Figure 57-4. show storm-control unknown-unicast Command Example (E-Series) FTOS#show storm-control unknown-unicast gigabitethernet 11/1 Unknown-unicast storm control configuration Interface Direction Percentage Wred Profile Gi 11/1 Ingress 5.9 - Gi 11/1 Egress 5.7 w8 FTOS# Example C-Series Figure 57-5. show storm-control unknown-unicast Command Example (C-Series) FTOS#show storm-control unknown-unicast gigabitethernet 3/0 Unknown-unicast storm control configuration Interface Direction Packets/Second Gi 3/0 Ingress 1000 FTOS# storm-control broadcast (Configuration) c e s Configure the percentage of broadcast traffic allowed in or out of the network. Syntax storm-control broadcast [percentage decimal_value in | out] | [wred-profile name]] [packets_per_second in] To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in | out] | [wred-profile name]] [packets_per_second in] command. 1412 | Storm Control