Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 361
network, route-map
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 361 highlights
peer-group-name weight Enter the name of the peer group to disable all routers within the peer group. Enter a number as the weight. Range: 0 to 65535 Default: 0 Defaults 0 Command Modes ROUTER BGP Usage Information In the FTOS best path selection process, the path with the highest weight value is preferred. Note: Reset the neighbor connection (clear ip bgp ipv4 unicast soft * command) to apply the weight to the connection and recompute the best path. If the set weight command is configured in a route map applied to this neighbor, the weight set in that command overrides the weight set in the neighbor weight command. Related Commands set weight Assign a weight to all paths meeting the route map criteria. Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series network c e s Specify the networks for the BGP process and enter them in the BGP routing table. Syntax network ip-address mask [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. Parameters ip-address mask route-map map-name Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Border Gateway Protocol IPv4 (BGPv4) | 361