Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1246

www.dell.com | support.dell.com Usage This command is intended for low-speed interfaces. Information passive-interface c e s Suppress routing updates on a specified interface. Syntax passive-interface interface To delete a passive interface, use the no passive-interface interface command. Parameters interface Enter the following information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes ROUTER RIP Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Although the passive interface will neither send nor receive routing updates, the network on that Information interface will still be included in RIP updates sent via other interfaces. Related Commands neighbor network Enable RIP for a specified network. Define a neighbor. redistribute c e s Redistribute information from other routing instances. Syntax redistribute {connected | static} To disable redistribution, use the no redistribute {connected | static} command. 1246 | Router Information Protocol (RIP)