Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1122
ipv6 pim dr-priority
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1122 highlights
www.dell.com | support.dell.com Parameters Defaults Command Modes Command History interface hash-mask-length priority As above CONFIGURATION Version 7.4.1.0 Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the hash mask length for RP selection. Range: 0 to 128 Default: 126 (OPTIONAL) Enter the priority value for Bootstrap election process. Range: 0 to 255 Default: 0 Introduced ipv6 pim dr-priority e Change the Designated Router (DR) priority for the IPv6 interface. Syntax ipv6 pim dr-priority priority-value To remove the DR priority value assigned, use the no ipv6 pim dr-priority command. Parameters priority-value Enter a number. Preference is given to larger/higher number. Range: 0 to 4294967294 Default: 1 Defaults 1 Command Modes INTERFACE Command History Version 7.4.1.0 Introduced Usage Information The router with the largest value assigned to an interface becomes the Designated Router. If two interfaces contain the same DR priority value, the interface with the largest interface IP address becomes the Designated Router. 1122 | PIM-Sparse Mode (PIM-SM)