Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1460

www.dell.com | support.dell.com Version 7.6.1.0 Support added for C-Series and S-Series E-Series original Command Usage Information You must remove the members prior to disabling the Stackable VLAN feature. To view the Stackable VLANs, use the show vlan command in the EXEC Privilege mode. Stackable VLANs contain members, designated by the M in the Q column of the command output. Figure 61-1. show vlan Command Example with Stackable VLANs FTOS#show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM * 1 2 3 4 5 FTOS# Status Inactive Active Active Active Active Q Ports M Gi 13/13 M Gi 13/0-2 M Po1(Gi 13/14-15) M Gi 13/18 M Gi 13/3 M Po1(Gi 13/14-15) M Gi 13/18 M Gi 13/4 M Po1(Gi 13/14-15) M Gi 13/18 M Gi 13/5 vlan-stack dot1p-mapping c s Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas, and dashed ranges are permitted. Dynamic Mode CoS overrides any Layer 2 QoS configuration in case of conflicts. Syntax vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value Parameters c-tag-dot1p value sp-tag-dot1p value Enter the keyword followed by the customer dot1p value that will be mapped to a service provider do1p value. Range: 0-7 Enter the keyword followed by the service provider dot1p value. Range: 0-7 Defaults None Command Modes INTERFACE Command History Version 8.3.1.0 Introduced on C-Series and S-Series. 1460 | VLAN Stacking