Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1490

www.dell.com | support.dell.com debug vrrp ipv6 e c s Allows you to enable debugging of VRRP. Syntax debug vrrp ipv6 interface [vrid] {all | packets | state | timer} Parameters interface vrid all bfd database packets state timer Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: E-Series Range: 1 to 255 for TeraScale • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN ID range is from 1 to 4094. (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID. Enter the keyword all to enable debugging of all VRRP groups. Enter the keyword bfd to enable debugging of all VFFP BFD interactions Enter the keyword database to display changes related to group, prefix, and interface entries in the VRRP table. Enter the keyword packets to enable debugging of VRRP control packets. Enter the keyword state to enable debugging of VRRP state changes. Enter the keyword timer to enable debugging of the VRRP timer. Command Modes EXEC Privilege Command History Version 8.4.1.0 Version 8.3.2.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Introduced on E-Series TeraScale Usage If no options are specified, debug is active on all interfaces and all VRRP groups. Information 1490 | Virtual Router Redundancy Protocol (VRRP)