Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 679

Command History Version 8.1.1.2 Version 8.1.1.0 Version 6.4.1.0 Introduced support for E-Series ExaScale E600i Introduced on E-Series ExaScale Introduced Example Figure 24-25. show protocol-termination-table Command Output FTOS#show protocol-termination-table linecard 2 port-set 0 Index Protocol Src-Port Dst-Port Queue DP Blk-Hole 0 ICMP any any Q0 0 No 1 UDP any 1812 Q7 6 No 2 UDP any 68 Q7 6 No 3 UDP any 67 Q7 6 No 4 TCP any 22 Q7 6 No 5 TCP 22 any Q7 6 No 6 TCP 639 any Q7 6 No 7 TCP any 639 Q7 6 No 8 TCP 646 any Q7 6 No 9 TCP any 646 Q7 6 No 10 UDP 646 any Q7 6 No 11 UDP any 646 Q7 6 No 12 TCP 23 any Q7 6 No 13 TCP any 23 Q7 6 No 14 UDP any 123 Q7 6 No 15 TCP any 21 Q7 6 No 16 TCP any 20 Q7 6 No 17 UDP any 21 Q7 6 No 18 UDP any 20 Q7 6 No 19 TCP 21 any Q7 6 No 20 TCP 20 any Q7 6 No 21 UDP 21 any Q7 6 No 22 UDP 20 any Q7 6 No 23 UDP any 69 Q7 6 No 24 UDP 69 any Q7 6 No 25 TCP any 161 Q7 6 No 26 TCP 161 any Q7 6 No 27 TCP 162 any Q7 6 No 28 TCP any 162 Q7 6 No 29 UDP any 161 Q7 6 No 30 UDP 161 any Q7 6 No 31 UDP any 162 Q7 6 No 32 UDP 162 any Q7 6 No 33 PIM-SM any any Q6 0 No 34 IGMP any any Q7 6 No 35 OSPF any any Q7 6 No VlanCPU ---------- EgPort -----CP CP CP CP CP CP RP2 RP2 RP1 RP1 RP1 RP1 CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP CP RP2 RP2 RP1 Usage Information Related Commands The IPPTT table is used for looking up forwarding information for IP control traffic destined to the router. For the listed control traffic types, IPPTT contains the information for the following: • Which CPU to send the traffic (CP, RP1, or RP2) • What QoS parameters to set show ip cam stack-unit Display the CAM table show tcp statistics c e s View information on TCP traffic through the switch. Syntax show tcp statistics {all | cp | rp1 | rp2} Parameters all cp Enter the keyword all to view all TCP information. Enter the keyword cp to view only TCP information from the Control Processor. IPv4 Routing | 679