Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 82

www.dell.com | support.dell.com enable xfp-power-updates c e s Enable XFP power updates for SNMP. Syntax enable xfp-power-updates interval seconds To disable XFP power updates, use the no enable xfp-power-updates command. Parameters interval seconds Enter the keyword interval followed by the polling interval in seconds. Range: 120 to 6000 seconds Default: 300 seconds (5 minutes) Defaults Disabled Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series and E-Series Usage Information The chassis MIB contain the entry chSysXfpRecvPower in the chSysPortTable table. Periodically, IFA polls the XFP power for each of the ports, and sends the values to IFM where it is cached. The default interval for the polling is 300 seconds (5 minutes). Use this command to enable the polling and to configure the polling frequency. end c e s Return to the EXEC Privilege mode from other command modes (for example, the CONFIGURATION or ROUTER OSPF modes). Syntax end Command Modes CONFIGURATION, SPANNING TREE, MULTIPLE SPANNING TREE, LINE, INTERFACE, TRACE-LIST, VRRP, ACCESS-LIST, PREFIX-LIST, AS-PATH ACL, COMMUNITY-LIST, ROUTER OSPF, ROUTER RIP, ROUTER ISIS, ROUTER BGP Command History Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Related Commands exit Return to the lower command mode. 82 | Control and Monitoring