Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 858
show isis protocol, show isis traffic
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 858 highlights
www.dell.com | support.dell.com show isis protocol e Display IS-IS routing information. Syntax show isis protocol Command Modes EXEC EXEC Privilege Example Figure 28-9. Command Example: show isis protocol FTOS#show isis protocol IS-IS Router: System Id: F100.E120.0013 IS-Type: level-1-2 Manual area address(es): 49.0000.0001 Routing for area address(es): 49.0000.0001 Interfaces supported by IS-IS: GigabitEthernet 1/0 - IP - IPv6 GigabitEthernet 1/1 - IP - IPv6 GigabitEthernet 1/10 - IP - IPv6 Loopback 0 - IP - IPv6 Redistributing: Distance: 115 Generate narrow metrics: level-1-2 Accept narrow metrics: level-1-2 Generate wide metrics: none Identifies that MT IS-IS is enabled. Accept wide metrics: none Multi Topology Routing is enabled in transition mode. FTOS# show isis traffic e This command enables you to display IS-IS traffic interface information. Syntax show isis traffic [interface] Parameters interface (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Command Modes EXEC EXEC Privilege 858 | Intermediate System to Intermediate System (IS-IS)