Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 266

www.dell.com | support.dell.com Usage Information Sequence numbers for this filter are automatically assigned starting at sequence number 5. If the options ge or le are not used, only packets with an exact match to the prefix are filtered. Related Commands deny seq Configure a filter to drop packets. Configure a drop or permit filter with a specified sequence number. seq c e s Assign a sequence number to a deny or permit filter in a prefix list while configuring the filter. Syntax seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge min-prefix-length} {le max-prefix-length}] | [bitmask number] Parameters sequence-number deny permit any ip-prefix /nn ge min-prefix-length le max-prefix-length bitmask number Enter a number. Range: 1 to 4294967294. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this condition. (OPTIONAL) Enter the keyword any to match any packets. (OPTIONAL) Specify an IP prefix in the network/length format. For example, 35.0.0.0/8 means match the first 8 bits of address 35.0.0.0. (OPTIONAL) Enter the keyword ge followed by the minimum prefix length, which is a number from zero (0) to 32. (OPTIONAL) Enter the keyword le followed by the maximum prefix length, which is a number from zero (0) to 32. Enter the keyword bitmask followed by a bit mask number in dotted decimal format. Defaults Not configured. Command Modes PREFIX-LIST Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.3.1.0 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Added bit mask option Usage If the options ge or le are not used, only packets with an exact match to the prefix are filtered. Information Related Commands deny permit Configure a filter to drop packets. Configure a filter to pass packets. 266 | Access Control Lists (ACL)