Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1398

www.dell.com | support.dell.com Parameters interface Enter the one of the following interface keywords and slot/port information: • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Command Modes EXEC Example EXEC Privilege Figure 55-4. show interfaces sonet with PPP Encapsulation Command Example (EtherScale) FTOS>show interfaces sonet 2/0 SONET 2/0 is up, line protocol is up Hardware is SONET, address is 00:01:e8:00:03:ff Encapsulation PPP, Framing is SONET, AIS-shut is enabled Scramble-ATM is enabled, Down-when-looped is enabled Loopback is disabled, Clock source is internal, Speed is Oc48 CRC is 32-bits, Flag C2 is 0x16, Flag J0 is 0xcc, Flag S1S0 is 0x0 Keepalive Set (10 Sec) LCP State: OPENED IPCP State: OPENED Internet address is 6.1.5.2/30 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 2488 Mbit ARP type: ARPA, ARP timeout 04:00:00 Last clearing of "show interfaces" counters 17:08:10 Queueing strategy: fifo 91425052815 packets input, 6188485730919 bytes Input 91425040617 IP Packets, 0 Vlans 0 MPLS Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 IP Checksum, 0 overrun, 0 discarded 55176128354 packets output, 3677188351652 bytes, 474 underruns Output 173858 Multicasts, 0 Broadcasts, 55175954550 Unicasts 55176116090 IP Packets, 0 Vlans, 0 MPLS 0 throttles, 474 discarded Rate info (interval 299 minutes): Input 1604.04Mbits/sec, 2583270 packets/sec Output 1169.30Mbits/sec, 1913510 packets/sec Time since last interface status change: 17:10:40 FTOS> Table 55-3. Fields in the show interfaces sonet with PPP Encapsulation Field Sonet 2/0... Hardware is... Encapsulation is... Scramble-ATM is enabled Loopback is... Keepalive Set LCP State: Description Displays the interface's type, slot/port and physical and line protocol status. Displays the interface's hardware information and its assigned MAC address. Displays the encapsulation method, the framing, and if the ais-shut command is enabled. States whether the scramble-atm and the down-when-looped commands are enabled. States whether the loopback, clock source, and speed, and flag commands are configured. This information is displayed over 2 lines. Displays the number of seconds between keepalive messages. States if LCP was successfully negotiated. 1398 | SONET