Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 589

Defaults Command Modes 299 seconds INTERFACE Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Usage The configured rate interval is displayed, along with the collected traffic data, in the output of show Information interfaces commands. Related Commands show interfaces Display information on physical and virtual interfaces. show config c e s Display the interface configuration. Syntax show config Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Figure 23-25. show config Command Example for the INTERFACE Mode FTOS(conf-if)#show conf ! interface GigabitEthernet 1/7 no ip address switchport no shutdown FTOS(conf-if)# show config (from INTERFACE RANGE mode) c e s Display the bulk configured interfaces (interface range). Syntax show config Command Modes CONFIGURATION INTERFACE (conf-if-range) Command History Version 8.1.1.0 Version 7.6.1.0 Introduced on E-Series ExaScale Introduced on S-Series Interfaces | 589