Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 596

www.dell.com | support.dell.com Usage On the C-Series and S-Series, the interface counter "over 1023-byte pkts" does not increment for Information packets in the range 9216 > x < 1023. The Management port is enabled by default (no shutdown). If necessary, use the ip address command to assign an IP address to the Management port. If two RPMs are installed in your system, use the show redundancy command to display which RPM is the Primary RPM. Related Commands show interfaces configured show interfaces linecard show interfaces phy show interfaces rate show interfaces switchport show inventory (C-Series and E-Series) show inventory (S-Series) show ip interface show linecard show range Display any interface with a non-default configuration. Display information on all interfaces on a specific line card. Display information of either rate limiting or rate policing on the interface. Display Layer 2 information about the interfaces. Display the chassis type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display the S-Series switch type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display Layer 3 information about the interfaces. Display the line card(s) status. Display all interfaces configured using the interface range command. Note: Unicast counters in the show interface output will increment when the interface receives multicast or broadcast packets.. 596 | Interfaces