Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1205

rate burst-KB Enter the outgoing rate in multiples of 10 Mbps. Range: 10 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 0 to 10000 Default: 10 Defaults Burst size is 10 KB. Granularity for rate is Mbps unless the kbps option is used. Command Modes QOS-POLICY-OUT Command History Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Added kbps option on C-Series, E-Series, and Series. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage rate-shape can be applied only as an aggregate policy. If it is applied as a class-based policy, then Information rate-shape will not take effect. On 40-port 10G line cards, if the traffic is shaped between 64 and 1000kbs, for some values the shaped rate is much less than the value configured. Do not use values in this range for 10G interfaces. Related Commands rate shape qos-policy-output Shape the traffic output of the selected interface. Create a QoS output policy. service-policy input c e s Apply an input policy map to the selected interface. Syntax service-policy input policy-map-name [layer2] To remove the input policy map from the interface, use the no service-policy input policy-map-name [layer2] command. Parameters policy-map-name layer2 Enter the name for the policy map in character format (16 characters maximum). You can identify an existing policy map or name one that does not yet exist. (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. Default: Layer 3 Defaults Layer 3 Command Modes INTERFACE Command History Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 pre-Version 6.1.1.1 Introduced on S-Series Introduced on C-Series E-Series Only: Expanded to add support for Layer 2 Introduced on E-Series Quality of Service (QoS) | 1205