Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 697

Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S-Series Introduced on the E-Series ExaScale Introduced on the C-Series Introduced on the E-Series TeraScale Added monitor option Usage The C-Series cannot count both packets and bytes, so when you enter the count byte options, only Information bytes are incremented. Most ACL rules require one entry in the CAM. However, rules with TCP and UDP port operators (gt, lt, range) may require more than one entry. The range of ports is configured in the CAM based on bitmask boundaries; the space required depends on exactly what ports are included in the range. For example, an ACL rule with TCP port range 4000 - 8000 uses 8 entries in the CAM: Rule# Data Mask From To #Covered 1 0000111110100000 1111111111100000 4000 4031 32 2 0000111111000000 1111111111000000 4032 4095 64 3 0001000000000000 1111100000000000 4096 6143 2048 4 0001100000000000 1111110000000000 6144 7167 1024 5 0001110000000000 1111111000000000 7168 7679 512 6 0001111000000000 1111111100000000 7680 7935 256 7 0001111100000000 1111111111000000 7936 7999 64 8 0001111101000000 1111111111111111 8000 8000 1 Total Ports: 4001 But an ACL rule with TCP port lt 1023 takes only one entry in the CAM: Rule# Data Mask From To #Covered 1 0000000000000000 1111110000000000 0 1023 1024 Total Ports: 1024 Related Commands permit permit udp Assign a permit filter for IPv6 packets. Assign a permit filter for UDP packets. permit udp c e s Configure a filter to pass UDP packets meeting the filter criteria. Syntax permit udp {source address mask | any | host ipv6-address} [operator port [port]] {destination address | any | host ipv6-address} [operator port [port]] [count [byte]] | [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no permit udp {source address mask | any | host ipv6-address} {destination address | any | host ipv6-address} command. IPv6 Access Control Lists (IPv6 ACLs) | 697