Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 928

www.dell.com | support.dell.com Defaults Not configured Command Modes EXEC Privilege Command History Version 6.2.1.1 Introduced clear ip msdp sa-cache e Clears the entire source-active cache, the source-active entries of a particular multicast group, rejected, or local source-active entries. Syntax clear ip msdp sa-cache [group-address | rejected-sa | local] Parameters group-address rejected-sa local Enter the group IP address in dotted decimal format (A.B.C.D.) Enter this keyword to clear the cache source-active entries that are rejected because the RPF check failed, an SA filter or limit is configured, the RP or MSDP peer is unreachable, or because of a format error. Enter this keyword to clear out local PIM advertised entries. It applies the redistribute filter (if present) while adding the local PIM SA entries to the SA cache. Defaults Without any options, this command clears the entire source-active cache. Command Modes EXEC Privilege Command History Version 7.8.1.0 Version 7.7.1.0 Version 6.2.1.1 Added local option. Added rejected-sa option. Introduced debug ip msdp e Turn on MSDP debugging. Syntax debug ip msdp {event peer address | packet peer address | pim} To turn debugging off, use the no debug ip msdp {event peer address | packet peer address | pim} command. Parameters event peer address packet peer address pim Enter the keyword event followed by the peer address in a dotted decimal format (A.B.C.D.). Enter the keyword packet followed by the peer address in a dotted decimal format (A.B.C.D.). Enter the keyword pim to debug advertisement from PIM. Defaults Not configured Command Modes EXEC Privilege 928 | Multicast Source Discovery Protocol (MSDP)