Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1056

www.dell.com | support.dell.com EXEC Privilege Command History Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series and E-Series Usage If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a Information specific OSPF process. If you do not enter the Process ID, only the first configured process is listed. This command is useful in isolating routing problems between OSPF and RTM. For example, if a route is missing from the RTM/FIB but is visible from the display output of this command, then likely the problem is with downloading the route to the RTM. This command has the following limitations: • The display output is sorted by prefixes; intra-area ECMP routes are not displayed together. • For Type 2 external routes, type1 cost is not displayed. Example Figure 38-18. Command Example: show ip ospf process-id routes FTOS#show ip ospf 100 route Prefix 1.1.1.1 3.3.3.3 13.0.0.0 150.150.150.0 172.30.1.0 FTOS# Cost 1 2 1 2 2 Nexthop 0.0.0.0 13.0.0.3 0.0.0.0 13.0.0.3 13.0.0.3 Interface Lo 0 Gi 0/47 Gi 0/47 Gi 0/47 Gi 0/47 Area 0 1 0 1 Type Intra-Area Intra-Area Intra-Area External Intra-Area show ip ospf statistics c e s Display OSPF statistics. Syntax show ip ospf process-id statistics global | [interface name {neighbor router-id}] Parameters process-id global Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Enter the keyword global to display the packet counts received on all running OSPF interfaces and packet counts received and transmitted by all OSPF neighbors. 1056 | Open Shortest Path First (OSPFv2 and OSPFv3)