Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 808

www.dell.com | support.dell.com redistribute c e Redistribute routes into BGP. Syntax redistribute [connected | static] [route-map map-name] To disable redistribution, use the no redistribution [connected | static] [route-map map-name] command. Parameters connected static route-map map-name Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series TeraScale Usage If you do not configure default-metric command, in addition to the redistribute command, or there is no Information route map to set the metric, the metric for redistributed static and connected is "0". To redistribute the default route (0::0/0) configure the neighbor default-originate command. Related Commands neighbor default-originate Inject the default route. show ip bgp ipv6 unicast c e View the current MBGP routing table for the E-Series. Syntax show ip bgp ipv6 unicast [network [network-mask] [length]] Parameters network network-mask longer-prefixes (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP network to view information only on that network. (OPTIONAL) Enter the network mask (in slash prefix format) of the BGP network address. (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a common prefix. 808 | IPv6 Border Gateway Protocol (IPv6 BGP)