Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 159

traceroute c e s View a packet's path to a specific device. Syntax traceroute {host | vrf instance | ip-address | ipv6-address} Parameters host vrf instance ip-address ipv6-address Enter the name of device. (Optional) E-Series Only: Enter the keyword vrf followed by the VRF Instance name. Enter the IP address of the device in dotted decimal format. Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity. Note: The :: notation specifies successive hexadecimal fields of zeros Defaults Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434 Command Modes EXEC EXEC Privilege Command History Version 8.4.1.0 IPv6 trace routing available on management interface. Version 8.2.1.0 Introduced on E-Series ExaScale with IPv6 Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4 only) Version 7.9.1.0 Introduced VRF. Version 7.6.1.0 Added support for S-Series Version 7.5.1.0 Introduced on C-Series Version 7.4.1.0 Added support for IPv6 address on E-Series E-Series original Command Usage Information When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default setting for those parameters, press the ENTER key. For the source IP address option, you may enter IPv6 global addresses only (link-local addresses are not supported). For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum hop count (default is 64). Control and Monitoring | 159