Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 347
neighbor graceful-restart
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
as-path-name in out Enter the name of an established AS-PATH access list (up to 140 characters). If the AS-PATH access list is not configured, the default is permit (allow routes). Enter the keyword in to filter inbound BGP routes. Enter the keyword out to filter outbound BGP routes. Defaults Not configured. Command Modes ROUTER BGP Usage Information Use the ip as-path access-list command syntax in the CONFIGURATION mode to enter the AS-PATH ACL mode and configure AS-PATH filters to deny or permit BGP routes based on information in their AS-PATH attribute. Related Commands Command History ip as-path access-list Enter AS-PATH ACL mode and configure AS-PATH filters. Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, ACL names are up to 16 characters long. Introduced support on C-Series neighbor graceful-restart c e s Enable graceful restart on a BGP neighbor. Syntax neighbor {ip-address | peer-group-name} graceful-restart [restart-time seconds] [stale-path-time seconds] [role receiver-only] To return to the default, enter the no bgp graceful-restart command. Parameters ip-address peer-group-name restart-time seconds stale-path-time seconds role receiver-only Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to apply the filter to all routers in the peer group. Enter the keyword restart-time followed by the maximum number of seconds needed to restart and bring-up all the peers. Range: 1 to 3600 seconds Default: 120 seconds Enter the keyword stale-path-time followed by the maximum number of seconds to wait before restarting a peer's stale paths. Default: 360 seconds. Enter the keyword role receiver-only to designate the local router to support graceful restart as a receiver only. Defaults as above Command Modes ROUTER BGP Border Gateway Protocol IPv4 (BGPv4) | 347