Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1406
stack-unit priority
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1406 highlights
www.dell.com | support.dell.com Table 56-1. show interfaces description Command Example Fields Field Link Speed Admin Status Connection Description Link Speed of the stack port (12 or 24) in Gb/s The only currently listed status is Up. The stack port ID to which this unit's stack port is connected Related Commands reset stack-unit show hardware stack-unit show system (S-Series) upgrade (S-Series management unit) Reset the designated S-Series stack member. Display the data plane or management plane input and output statistics of the designated component of the designated stack member. Display the current status of all stack members or a specific member. Upgrade the bootflash image or system image of the S-Series management unit. stack-unit priority s Configure the ability of an S-Series switch to become the management unit of a stack. Syntax stack-unit 0-7 priority 1-14 Parameters 0-7 1-14 Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to set the management priority. This preference parameter allows you to specify the management priority of one backup switch over another, with 0 the lowest priority and 14 the highest. The switch with the highest priority value will be chosen to become the management unit if the active management unit fails or on the next reload. Defaults 1 Command Modes CONFIGURATION Command History Version 7.7.1.0 Introduced on S-Series Related Commands reload show system (S-Series) Reboot FTOS. Display the current status of all stack members or a specific member. 1406 | S-Series Stacking Commands