HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 119
nssa
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Use undo network to disable OSPF for the interface attached to the specified network in the area. Syntax network ip-address wildcard-mask undo network ip-address wildcard-mask Default OSPF is not enabled for any interface. Views OSPF area view Predefined user roles network-admin View OSPF area view Parameters ip-address: Specifies the IP address of a network. wildcard-mask: Specifies the wildcard mask of the IP address. For example, the wildcard mask of mask 255.0.0.0 is 0.255.255.255. Usage guidelines This command enables OSPF on the interface attached to the specified network. The interface's primary IP address must be in the specified network. If only the interface's secondary IP address is in the network, the interface cannot run OSPF. Examples # Specify the interface whose primary IP address falls into 131.108.20.0/24 to run OSPF in Area 2. system-view [Sysname] ospf 100 [Sysname-ospf-100] area 2 [Sysname-ospf-100-area-0.0.0.2] network 131.108.20.0 0.0.0.255 Related commands ospf nssa Use nssa to configure the current area as an NSSA area. Use undo nssa to restore the default. Syntax nssa [ default-route-advertise | no-import-route | no-summary | translate-always | translator-stability-interval value ] * undo nssa Default No area is configured as an NSSA area. 108