HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 185

Default The priority of Level-1 and Level-2 is 64. Views Interface view Predefined user roles network-admin Parameters value: Specifies a DIS priority in the range of 0 to 127. level-1: Applies the DIS priority to Level-1. level-2: Applies the DIS priority to Level-2. Usage guidelines If neither level-1 nor level-2 is specified, the DIS priority applies to both Level-1 and Level-2. On an IS-IS broadcast network, a router must be elected as the DIS at each routing level. Specify a DIS priority at a level for an interface. The greater the interface's priority is, the more likelihood it becomes the DIS. If multiple routers in the broadcast network have the same highest DIS priority, the router with the highest Subnetwork Point of Attachment (SNPA) address (SNPA addresses are MAC addresses on a broadcast network) becomes the DIS. IS-IS has no backup DIS. The router with a priority of 0 can also participate in DIS election. Examples # Configure the Level-2 DIS priority as 127 for VLAN-interface 10. system-view [Sysname] interface vlan-interface 10 [Sysname-Vlan-interface10] isis dis-priority 127 level-2 isis enable Use isis enable to enable an IS-IS process on an interface. Use undo isis enable to disable IS-IS. Syntax isis enable [ process-id ] undo isis enable Default No IS-IS process is enabled on an interface. Views Interface view Predefined user roles network-admin Parameters process-id: Specifies an IS-IS process by its ID in the range of 1 to 65535. The default is 1. 174