HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 126

Use undo ospf mib-binding to restore the default. Syntax ospf mib-binding process-id undo ospf mib-binding Default MIB operation is bound to the OSPF process with the smallest process ID. Views System view Predefined user roles network-admin Parameters process-id: Specifies an OSPF process by its ID in the range of 1 to 65535. Examples # Bind MIB operation to OSPF process 100. system-view [Sysname] ospf mib-binding 100 ospf mtu-enable Use ospf mtu-enable to enable an interface to add the interface MTU into DD packets. Use undo ospf mtu-enable to restore the default. Syntax ospf mtu-enable undo ospf mtu-enable Default The MTU in DD packets is 0. Views Interface view Predefined user roles network-admin Usage guidelines After a virtual link is established through a Tunnel, two devices on the link from different vendors might have different MTU values. To make them consistent, restore the interfaces' MTU to the default value 0. After you configure this command, the interface checks whether the MTU in a received DD packet is greater than its own MTU. If yes, the interface discards the packet. Examples # Enable VLAN-interface 10 to add the interface MTU value into DD packets. system-view [Sysname] interface vlan-interface 10 115