HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 403
stub (OSPFv3 area view), vlink-peer (OSPFv3 area view
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
stub (OSPFv3 area view) Use stub to configure an area as a stub area. Use undo stub to restore the default. Syntax stub [ default-route-advertise-always | no-summary ] * undo stub Default No area is configured as a stub area. Views OSPFv3 area view Predefined user roles network-admin Parameters default-route-advertise-always: Enables the ABR to always advertise the default route. no-summary: Enables the ABR of a stub area to advertise only a default route in an Inter-Area-Prefix-LSA into the stub area. No AS-external-LSA, Inter-Area-Prefix-LSA, or other Inter-Area-Router-LSA is advertised in the area. The stub area of this kind is also known as a "totally stub area." Usage guidelines To remove the no-summary configuration on an ABR, execute the stub command again to overwrite it. To configure an area as a stub area, issue the stub command on all routers attached to the area. Examples # Configure OSPFv3 area 1 as a stub area. system-view [Sysname] ospfv3 1 [Sysname-ospfv3-1] area 1 [Sysname-ospfv3-1-area-0.0.0.1] stub Related commands default cost (OSPFv3 area view) vlink-peer (OSPFv3 area view) Use vlink-peer to configure a virtual link. Use undo vlink-peer to remove a virtual link. Syntax vlink-peer router-id [ dead seconds | hello seconds | instance instance-id | retransmit seconds | trans-delay seconds ] * undo vlink-peer router-id [ dead | hello | retransmit | trans-delay ] * 392