HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 140
stub-router
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Usage guidelines To remove the default-route-advertise-always or stub no-summary configuration on the ABR, execute the stub command again to overwrite it. To configure an area as a stub area, issue the stub command on all routers attached to the area. Examples # Configure Area 1 as a stub area. system-view [Sysname] ospf 100 [Sysname-ospf-100] area 1 [Sysname-ospf-100-area-0.0.0.1] stub Related commands default-cost stub-router Use stub-router to configure a router as a stub router. Use undo stub-router to restore the default. Syntax stub-router undo stub-router Default No router is a stub router. Views OSPF view Predefined user roles network-admin Usage guidelines The router LSAs sent by the stub router over different links contain different link type values. A value of 3 represents a link to a stub network, and the cost of the link is not changed. A value of 1, 2, or 4 represents a point-to-point link, a link to a transit network, or a virtual link, and the cost of such links is set to 65535. Neighbors on such links will not send packets to the stub router as long as they have a route with a smaller cost. Examples # Configure a stub router. system-view [Sysname] ospf 100 [Sysname-ospf-100] stub-router 129