HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 425
ipv6 policy-based-route (system view
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 425 highlights
Default No IPv6 is applied to an interface. Views Interface view Predefined user roles network-admin Parameters policy-name: Specifies a policy by its name, a case-sensitive string of 1 to 19 characters. The specified policy must already exist. Usage guidelines You can apply only one policy to an interface. Before you apply a new policy, remove the current policy from the interface. Examples # Apply policy aaa to VLAN-interface 2. system-view [Sysname] vlan 2 [Sysname-Vlan2] interface vlan-interface 2 [Sysname-Vlan-interface2] ipv6 policy-based-route aaa Related commands • display ipv6 policy-based-route setup • ipv6 policy-based-route (system view) ipv6 policy-based-route (system view) Use ipv6 policy-based-route to create an IPv6 policy or policy node and enter IPv6 policy node view. If the specified IPv6 policy node already exists, the command directly places you into IPv6 policy node view. Use undo ipv6 policy-based-route to remove an IPv6 policy or IPv6 policy node. Syntax ipv6 policy-based-route policy-name [ deny | permit ] node node-number undo ipv6 policy-based-route policy-name [ deny | node node-number | permit ] Default No IPv6 policy node is created. Views System view Predefined user roles network-admin Parameters policy-name: Specifies a policy name, a case-sensitive string of 1 to 19 characters. 414