HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 381
filter (OSPFv3 area view), Table 90, Command output
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 381 highlights
Table 90 Command output Field Virtual-link Neighbor-ID Neighbor-State Interface Cost State Type Transit Area Timers Description ID of the neighbor on the virtual link. Neighbor state: Down, Init, 2-Way, ExStart, Exchange, Loading, or Full. IP address and name of the local interface on the virtual link. Interface route cost. Interface state. Virtual link. Transit area ID. (This field is displayed when a virtual link is present on the interface.) Values of OSPFv3 timers (in seconds): hello, dead, and retransmit, and interface transmission delay. filter (OSPFv3 area view) NOTE: This command is available only on an ABR. Use filter to configure inbound/outbound Inter-Area-Prefix-LSA filtering on an ABR. Use undo filter to remove the configuration. Syntax filter { acl6-number | prefix-list prefix-list-name | route-policy route-policy-name } { export | import } undo filter { export | import } Default Inter-Area-Prefix-LSAs are not filtered. Views OSPFv3 area view Predefined user roles network-admin Parameters acl6-number: Specifies an IPv6 ACL by its number in the range of 2000 to 3999 to filter inbound/outbound Inter-Area-Prefix-LSAs. prefix-list-name: Specifies an IPv6 prefix list by its name, a case-sensitive string of 1 to 63 characters, to filter inbound/outbound Inter-Area-Prefix-LSAs. route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters, to filter inbound/outbound Inter-Area-Prefix-LSAs. export: Filters Inter-Area-Prefix-LSAs advertised to other areas. import: Filters Inter-Area-Prefix-LSAs advertised into the local area. 370