HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Routing Command Referenc - Page 127
ospf network-type
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
[Sysname-Vlan-interface10] ospf mtu-enable ospf network-type Use ospf network-type to set the network type for an interface. Use undo ospf network-type to restore the default network type for an interface. Syntax ospf network-type { broadcast | nbma | p2mp [ unicast ] | p2p } undo ospf network-type Default By default, the network type of an interface depends on its link layer protocol: • For Ethernet and FDDI, the network type is broadcast. • For ATM, FR, and X.25, the network type is NBMA. • For PPP, LAPB, HDLC, and POS, the network type is P2P. Views Interface view Predefined user roles network-admin Parameters broadcast: Specifies the network type as broadcast. nbma: Specifies the network type as NBMA. p2mp: Specifies the network type as P2MP. unicast: Specifies the P2MP interface to unicast OSPF packets. By default, a P2MP interface multicasts OSPF packets. p2p: Specifies the network type as P2P. Usage guidelines If a router on a broadcast network does not support multicast, configure the network type for the connected interfaces as NBMA. If any two routers on an NBMA network are directly connected through a virtual link, the network is fully meshed, and you can configure the network type for the connected interfaces as NBMA. If two routers are not directly connected, configure the P2MP network type so that the two routers can exchange routing information through another router. When the network type of an interface is NBMA or P2MP unicast, you must use the peer command to specify the neighbor. If only two routers run OSPF on a network, you can configure the network type for the connected interfaces as P2P. When the network type of an interface is P2MP unicast, all OSPF packets are unicast by the interface. Examples # Configure the OSPF network type for VLAN-interface 10 as NBMA. system-view 116